Filter
Top Products
4
GB
Getting Started
Unpacking
Check that you received the following items with the
processor:
• Remote commander (remote) (1)
• Size AA (R6) batteries (2)
• Connecting cords (3)
Inserting batteries into the remote
Insert two size AA (R6) batteries with the + and – on
the battery compartment. When using the remote,
point it at the remote sensor g on the processor.
z When to replace batteries
Under normal use, the batteries should last for about 6
months. When the remote no longer operates the
processor, replace both batteries with new ones.
Notes
• Do not leave the remote in an extremely hot or humid
place.
• Do not use a new battery with an old one.
• Do not expose the remote sensor to direct sunlight or
lighting apparatuses. Doing so may cause a malfunction.
• If you don’t use the remote for an extended period of time,
remove the batteries to avoid possible damage from
battery leakage and corrosion.
Before you get started
• Do not connect the power cord to the mains or press
the POWER switch before completing all
connections.
• The cable connectors should be fully inserted into the
jacks. Loose connection may cause hum and noise.
Source Component Hookups
The surround processor allows you to connect up to 3
digital audio (video) source components, such as a
DVD player, LD player (with AC-3 RF output) and CD
player (etc.). You can also connect 1 analog source
component, such as a VCR.
What cords will I need?
• Optical digital connecting cord (not supplied)
• Coaxial digital connecting cord (not supplied)
• Video cable (not supplied)
• Audio/video cable (not supplied)
Make sure to match the colour of the plugs and the jacks:
• Yellow jacks and plugs: Video signal
• Red jacks and plugs: Right audio channel
• White jacks and plugs: Left audio channel
a DIGITAL 1
b DIGITAL 2c DIGITAL 3
d ANALOG
White (L)
White (L)
Red (R)
Red (R)
Yellow Yellow
Yellow Yellow
]
}
]
}