Filter
Top Products
10
If the recording does not start
• Make sure the recorder is not locked
(page 29).
• Make sure the MD is not record-protected
(page 43).
• Premastered MDs cannot be recorded over.
For the models supplied with the AC
plug adaptor
If the AC power adaptor does not fit the wall
outlet, use the AC plug adaptor.
Note
If the power supply is disrupted (i.e. the battery
is removed or becomes exhausted or the AC
power adaptor is disconnected) during a
recording or editing operation, or while “TOC
Edit” appears in the display, then it will not be
possible to open the lid until power is restored.
z
• The level of the recorded sound is adjusted
automatically.
• You can monitor the sound during recording.
Connect the supplied headphones with remote
control to i/LINE OUT and adjust the
volume by pressing VOL +/–. This does not
affect the recording level.
To Press
Record from the end of the previous
recording
END SEARCH and slide REC.
Record partway through the previous
recording
N, > or . to find the start point of
recording and press x to stop. Then slide
REC.
Pause X
1)
Press X again to resume recording.
1)
A track mark is added at the point where you press X again to resume recording while pausing; thus
the remainder of the track will be counted as a new track.
Remove the MD x and open the lid.
2)
(The lid does not open
while “TOC Edit” flashing in the display.)
2)
Once you open the lid, the point to start recording will change to the beginning of the first track. Check
the point to start recording on the display.