Sony MHC-RG70AV Stereo System User Manual


 
14
Listening to the radio
Preset Tuning
Preset radio stations in the tuners memory first
(see Presetting radio stations on page 13).
1 Press TUNER/BAND repeatedly to
select FM or AM.
2 Press . or > (or press PRESET
or + on the remote) repeatedly to tune
in the desired preset station.
Preset number Frequency*
To erase a preset station
1 Press and hold TUNER MEMORY until a
preset number appears in the display.
2 Press . or > (or PRESET or + on
the remote) repeatedly to select the preset
number you want to erase.
Select ALL ERASE when you want to
erase all the preset stations.
3 Press ENTER.
COMPLETE appears.
When you erase a preset number, the preset
number decreases by one and all preset
numbers following the erased one are
renumbered.
To change the AM tuning interval
(except for the European and Middle
Eastern models)
The AM tuning interval is factory-set to 9 kHz
(10 kHz in some areas). To change the AM
tuning interval, tune in any AM station first,
then turn off the system. While holding down
ENTER, turn the system back on. When you
change the interval, all the AM preset stations
are erased. To reset the interval, repeat the
same procedure.
Tip
The preset stations are retained for half a day even if
you unplug the power cord or if a power failure
occurs.
* When only one station is preset, ONE
PRESET appears in the display.
To listen to non-preset radio stations
Use manual or automatic tuning in step 2.
For manual tuning, press + or (or TUNING +
or on the remote) repeatedly. For automatic
tuning, press and hold + or (or TUNING + or
on the remote).
Tips
When an FM stereo program has static noise, press
STEREO/MONO repeatedly until MONO
appears. There will be no stereo effect, but the
reception will improve.
To improve broadcast reception, adjust the supplied
antennas.
Presetting radio stations (continued)