Filter
Top Products
12
GB
You can make a program of up to 25 steps from
all the discs in the order you want to play them.
You can synchro record the programmed tracks
onto a cassette tape (page 17).
MP3 audio tracks cannot be played on
MHC-GX25 and MHC-RG220 (except for
European and Russian models).
Using the display window
1 Press CD.
2 Press PLAY MODE in stop mode
repeatedly until “PGM” appears.
3 Press D.SKIP (or DISC 1 – 3 or DISC
SKIP/EX-CHANGE on the unit) to select
a disc.
To program all the tracks on a disc at once,
proceed to step 5 with “AL” displayed.
4 Press . or > repeatedly until the
desired track number appears.
When programming an MP3, press
ALBUM – or + to select album, then press
. or > repeatedly until the desired
track number appears.
5 Press ENTER.
The track is programmed.
The program step number appears,
followed by the total playing time.
6 Program additional discs or tracks.
7 Press N.
Program Play starts.
Other operations
Tips
• The program you made remains after Program Play
finishes. To play the same program again, press CD,
then press N. However, the program is cleared
when you open the disc tray.
• “– –.– –” appears when the total CD program time
exceeds 100 minutes, or when you select a CD track
whose number is 21 or over, or when you select an
MP3 audio track.
Creating your own
program
— Program Play
Selected track number
Disc tray number
Total playing time
(including selected track)
To program Repeat steps
Other discs 3 and 5
Other tracks on the
same disc
4 and 5
Other tracks on
other discs
3 to 5
To Do this
Cancel Program
Play
Press PLAY MODE in stop
mode repeatedly until “PGM”
disappears.
Clear a track from
the end
Press CLEAR in stop mode.