Filter
Top Products
50
US
The FM reception is poor.
Use a 75-ohm coaxial cable (not supplied) to
connect the receiver to an outdoor FM antenna as
shown below. If you connect the receiver to an
outdoor antenna, ground it against lightning. To
prevent a gas explosion, do not connect the ground
wire to a gas pipe.
Radio stations cannot be tuned in.
• Check that the antennas are connected securely.
Adjust the antennas and connect an external
antenna if necessary.
• The signal strength of the stations is too weak
(when tuning in with automatic tuning). Use
direct tuning.
• Make sure you set the tuning interval correctly
(when tuning in AM stations with direct tuning).
• No stations have been preset or the preset
stations have been cleared (when tuning by
scanning preset stations). Preset the stations
(page 32).
• Press DISPLAY so that the frequency appears in
the display.
Outdoor FM antenna
Receiver
Ground wire
(not supplied)
To ground
ANTENNA
AM
FM
75
Ω
COAXIAL
Troubleshooting (continued)
There is no picture or an unclear picture appears
on the TV screen or monitor.
• Select the appropriate function on the receiver.
• Set your TV to the appropriate input mode.
• Move your TV away from the audio components.
The remote does not function.
• The VIDEO3, TV/SAT, PHONO, AUX,
SOURCE, MPX/DUAL, ANALOG DIRECT, 12
and ON SCREEN buttons on the remote are not
available for HT-6500DP and HT-5500D (RM-
PP411 only).
• The MULTI CH button on the remote is not
available for HT-1700D (RM-U306 only).
• Point the remote at the remote sensor g on the
receiver.
• Check that the mode of the remote corresponds
to that of the receiver (pages 35 and 40)
(RM-PP411 only).
• Check that you select AV2 as the command
mode of the receiver (page 35) (RM-U306 only).
• Remove any obstacles in the path between the
remote and the receiver.
• Replace both batteries in the remote with new
ones, if they are weak.
• Make sure you select the correct function on the
remote.
• If the remote is set to operate the TV only, use
the remote to select a source or component other
than TV before operating the receiver or other
component.
• Press MAIN MENU on the remote before you
use the V/v/B/b buttons for receiver operation
(RM-PP411 only).
Clearing the receiver’s memory
To clear See
All memorized settings page 15
Customized sound fields page 30