Filter
Top Products
Getting Started
7
Getting Started
Inserting Batteries Into
the Remote Control (CDP-
XE570/XE370 only)
You can control the player using the supplied
remote.
Insert two R6 (size AA) batteries by matching
the + and – on the batteries to the diagram
inside the battery compartment.
Insert the negative (–) end first, then push in
and down until the positive (+) end clicks into
position.
When using the remote, point it at the remote
sensor
on the player.
Tip
When the remote no longer operates the system,
replace both batteries with new ones.
Note
• Do not leave the remote near an extremely hot or
humid place.
• Do not drop any foreign object into the remote
casing, particularly when replacing the batteries.
• Do not expose the remote sensor to direct sunlight
or lighting apparatuses. Doing so may cause a
malfunction.
• If you don’t use the remote for an extended period
of time, remove the batteries to avoid possible
damage from battery leakage and corrosion.
Hooking Up the System
Hookups
This section describes how to hook up the CD
player to an amplifier. Be sure to turn off the
power of each component before making the
connections.
Tip (CDP-XE570/XE370 only)
You can adjust the analog output level to the
amplifier using the remote comes with this player.
Press ANALOG OUT LEVEL +/– on the remote.
You can reduce the analog output level up to –20 dB.
When you reduce the analog output level, “FADE”
(or
FADE
for the CDP-XE370) appears in the display.
When you turn off the player, the output level
automatically returns to the maximum level.
Setting the voltage selector
(voltage selector equipped
models only)
Check that the voltage selector on the rear
panel of the player is set to the local power line
voltage. If not, set the selector to the correct
position using a screwdriver before connecting
the AC power cord to a wall outlet.
CD player
Audio input
(White) (L)
: Signal flow
Amplifier
To mains
To mains
Audio input
(Red) (R)
ANALOG
OUT
(Red) (R)
ANALOG OUT
(White) (L)
continued
110 - 120 V220 - 240 V