Filter
Top Products
Playing CDs
20
EN
1 Press MEGA CONTROL on this player.
The MEGA CONTROL button and “2nd” in the
display light up. The display shows the current
disc number or disc memo of the second player.
≠/±
JOG
pP
·
Current disc number or the Disc Memo
Play mode buttons
(CONTINUE/SHUFFLE/
PROGRAM/REPEAT)
Controlling Another CD Player
(Advanced Mega Control)
(CDP-CX240 only)
This unit can control a second CD player (see
“Connecting Another CD Player” on page 6).
Even when a second CD player is connected, the
controls on both of the units will function. When you
press the play button on either unit, the operating
player stops and the resting player starts.
Make sure “2nd DETECTED” appears in this player’s
display after turning on both players.
Note that depending on the player, you may not be
able to operate all the functions of the second CD
player.
The controls indicated in the illustration below are effective
while the MEGA CONTROL button is lit.
2 Select the play mode you want.
To program tracks, use the controls on the second
player.
You cannot change the second CD player’s ALL
DISCS Play mode to 1 DISC Play mode, and vice
versa, by using the play mode button on this
player.
3 Press · on this player to start playing.
The play starts and the display shows the current
disc and track numbers and the playing time of the
track.
While the MEGA CONTROL button is lit, you can
control the second player with the controls on this
player.
To control the second player directly using the supplied
remote
Set CD 1/2/3 on the remote to CD 3 which is the same
position as the COMMAND MODE selector on the rear panel
of the second player.
To control this player again
Press MEGA CONTROL. The MEGA CONTROL button goes
off and you can control this player.
Loading the Disc Memos of the second CD
player
If the second CD player has the Disc Memo function
(see page 23), you can load the Disc Memos of the
second CD player to this player’s memory and display
them on this player.
1 Press INPUT.
2 Turn the JOG dial until “LOAD 2ND MEMO”
appears in the display.
0/)
ALL DISCS
CD1
2nd DISC
4
*DISC-4*
ALL DISCS
CD1
LOAD 2ND MEMO
INPUT
MEGA CONTROL