Sony CDP-CX240 Stereo System User Manual


 
Playing CDs
18
EN
3 Press the number button of the disc.
>10
DISC
CHECK
·
PROGRAM
Number
buttons
ENTER
CLEAR
1 Press PROGRAM until the program number you
want (PROGRAM 1, 2 or 3) appears in the display.
2 Press DISC.
4 To program a whole disc, press ENTER and go to
Step 6.
Press >10.
5 Press the number button of the track.
When the disc has more than 10 tracks, press 0 first
then press the corresponding number to enter a
track number from 1 to 9.
4 Push the JOG dial.
5 To program other discs/tracks, do the following:
To program
All tracks of another disc(s)
Other tracks on the same disc
Other tracks on other discs
6 Push the JOG dial or press · to start Program
Play.
To cancel Program Play
Press CONTINUE.
The programs remain even after Program Play ends
When you push the JOG dial or press ·, you can play
the same program again.
When you press PROGRAM to select Program Play
during Continuous or Shuffle Play
The program will be played after the current track.
The program remains until you erase them
Even if you replace discs, the programmed disc and track
numbers remain. So, the player plays only the existing
disc and track numbers. However, the disc and track
numbers that are not found in the player or on the disc
are deleted from the program, and the rest of the
program is played in the programmed order.
Note
If you press one of the GROUP 1 – 8 buttons to start Group
Play, Program Play will be canceled (see page 27).
Repeat Steps
2 and 4
3 and 4
2 to 4
The disc being
programmed
Playing order
The track being programmed
Creating a program using the remote Z
The disc being programmed
The track being programmed
Playing order
PROGRAM
1
CD1
DISC
TRACK
STEP
20
20 3 1
PROGRAM
1
CD1
DISC-[ _]
02
PROGRAM
1
CD1
DISC-[ 20]
02
PROGRAM
1
CD1
DISC
TRACK
STEP
20 -- 1
02
PROGRAM
1
DISC
TRACK
STEP
20
20 3 1