Sony CDP-CX220 Stereo System User Manual


 
Playing CDs
14
EN
Each time you press /±, the characters
appear in the following order.
A B C D E F G H I J K L M N O P Q R S T U V W X
Y Z 0 1 2 3 4 5 6 7 8 9
If “NOT FOUND” appears in the display while
inputting the first character with the ≠/±
buttons, no disc has been labeled using the input
character.
Notes
When searching input characters, blanks and symbols
before the first character in the Disc Memo are ignored.
When searching input characters, upper and lower
cases cannot be differentiated.
3 Turn the JOG dial to find the disc you want.
As you turn the JOG dial, the Disc Memos starting
with the input character appear in the display.
4 Push the JOG dial to select the disc.
In Program Play mode, the disc will be added to
the end of the program.
To cancel Memo Search
Press MEMO SEARCH again.
If there is no more Disc Memo starting with the input
character in Step 3
The input character changes to the next one when you
turn the JOG dial.
Input character
ALL DISCS
CD1
S
SONYHITS
Selecting a disc on the player
Turn the JOG dial until the disc number or Disc Memo
(see page 23) you want appears in the display. Push the
JOG dial to start play.
Selecting a disc directly using the remote
1 Press DISC.
2 Press the number button of the disc.
Example: To enter number 35
Press 3 then 5.
To enter number 100
Press 1, then 10/0 twice.
3 Press ENTER to start play.
Locating a disc by scanning each Disc
Memo (Memo Scan) Z
You can locate a disc you want to play quickly by
scanning the Disc Memos (see page 23) in the display .
Note that you cannot use this function in the ALL
DISCS Shuffle Play mode.
1 Press MEMO SCAN.
“MEMO SCAN” appears in the display, and the
Disc Memos scroll in the display.
2 Press · when the Disc Memo of the disc you
want to play appears.
The disc is set to the playing position, and the
player starts playing.
In Program Play mode, the disc will be added to
the end of the program if you press ENTER instead
of ·.
Note
If “NO ENTRY” appears in the display, no disc has been
labeled with the Disc Memo. Try the Memo Scan function
again after labeling the discs.
Locating a disc by searching a specific Disc
Memo (Memo Search)
You can search and locate a disc you want by inputting
the first character used in the Disc Memo (see page 23).
1 Press MEMO SEARCH.
“MEMO SEARCH” appears in the display.
2 Press ≠/± repeatedly to input the first
character.