Filter
Top Products
Playing Discs
13
GB
Turning off the information in
the display
Each time you press DISPLAY MODE on the
remote while playing a disc, the display turns off
and on alternately.
Even when the display is turned off, the display
turns on if you pause or stop play. When you
resume play, the display turns off again.
Before you start playing, when you press
DISPLAY MODE to turn off the display, “DISP
OFF” appears, and when you press the button to
turn on the display, “DISP ON” appears.
Displaying the information of
a TEXT disc in other
languages
You can change the displayed language if the
TEXT disc has multi language capacity. When
the player detects such a TEXT disc, “MULTI-
TEXT” appears in the display. Change the
language according to the procedures below.
1 Press MENU on the player.
2 Turn . AMS > until “LANGUAGE”
appears in the display.
3 Press . AMS >.
The current selected language (ENGLISH,
FRENCH, GERMAN, etc.) flashes.
If the player cannot display the language
used in a TEXT disc, “OTHER LANG”
appears in the display.
4 Turn . AMS > until the desired
language appears in the display.
5 Press . AMS >.
After a few seconds, the information
appears in the selected language.
You can locate a particular point in a track
during play or play pause.
Tip
When “OVER” appears in the display, the disc has
reached its end. Press and hold m to go back.
Note
Tracks that are only a few seconds long may be too
short for monitoring. In this case, the player may not
search correctly.
Locating a Particular
Point in a Track
Locating a point Do the following:
While monitoring the
sound (Search)
Press and hold m/M
during play.
By observing the
time indication
(High-Speed Search)
Press and hold m/M
during play pause.
By setting the start
time (Time Search)
1 Turn . AMS > in
stop mode to select the
desired track.
2 Press and hold m/M to
set the time to start play
while looking at the display,
then press N.