Filter
Top Products
9
GB
Getting Started
Rear
E LINK indicator
Indicates the connection status of the
wired/wireless LAN.
Green: Wireless connection (page 14).
Amber: Wired connection (page 18).
Red: The following status have occurred.
– This unit cannot find the wireless
LAN access point.
– The security method/password
selected for the access point is wrong.
– An error has occurred.
Not lit: The wireless network setting
process is not finished.
F WPS button
Use to make the network settings for the
WPS push button configuration (page 16).
G AUDIO IN button/indicator
Press to switch the input between the home
network and the audio input.
Lights up in green when the audio input is
selected.
This indicator goes off when the unit
connects to your home network (with
either a wireless or wired connection).
H AUDIO IN terminal
Use to connect the audio output jack of an
external component.
I (LAN) port
Use to connect the network (LAN) cable.
J VOLUME+/– buttons
Use to adjust the volume. The illumination
indicator flashes when the volume level is
set to either minimum or maximum.
K Power switch
Slide the switch to turn the power on or off.
Note
You cannot operate this unit via a home network
when the power switch is set to OFF. Set the unit
to the network standby mode when you want to
operate the unit via a home network. Refer to
“To set the network standby mode” (page 13).
L DC IN terminal
Use to connect the supplied AC adaptor
(page 12).