Filter
Top Products
7-EN
Record an MD.
3
1 Slide REC to the right while
pressing its button.
“REC” lights up and recording starts.
2 Play the CD or tape you want to
record.
To stop recording, press p .
”Toc Edit” flashes to record data of the
recording (the track’s start and end points,
etc.). Do not move or jog the recorder or
disconnect the power source while the
indication is flashing in the display.
CD player, cassette
recorder, etc. (source)
To
Pause
Add recording to the end of the
previous recording.
Record over partway through the
previous recording.
Remove the MD.
Press
P
1)
Press P again to resume recording.
END SEARCH and slide REC.
( , + or = to find the start point
of recording and press p to stop. Then
slide REC.
p and open the lid.
2)
1)
A new track is added at the point where you pressed P , and the recording will be marked with
the new track number when you resume recording.
2)
Once you open the lid, the point to start recording will change to the beginning of the first track.
When recording on a recorded MD, check the point to start recording on the display.
If the recording does not start
•Make sure the recorder is not locked (page
18).
•Make sure the MD is not record-protected
(page 27).
•Premastered MDs cannot be recorded over.
For models supplied with the AC plug
adaptor
If the AC power adaptor does not fit the wall
outlet, use the AC plug adaptor.
z
•The level of the recorded sound is adjusted
automatically.
•You can monitor the sound being recorded.
Connect the supplied headphones with
remote controller to 2/REMOTE and
adjust the volume by pressing VOLUME
+/– (VOL +/– on the remote controller).
Sound levels are copied onto the MD
automatically and independently of the
volume for monitoring.
REC