Filter
Top Products
45
4 Press . or > repeatedly until
the following item appears in the
display, and then press ENTER.
The cursor flashes in the letter input
area and the track, group, or disc is
ready to be labeled.
5 Press VOL + or – to select a letter and
press ENTER.
The selected letter appears and the
cursor moves to the next input
position.
The buttons used for character input
and their functions are listed below.
6 Repeat step 5, and then enter all
characters of the label name.
7 Press ENTER for 2 seconds or more.
A track or disc is labeled.
To return the preceding
setting
Press x.
To cancel labeling
Press x for 2 seconds or more.
Note
When the recording is stopped while labeling a
track or a disc during recording, or when the
recording moves on to the next track while
labeling a track, the input at that point is entered
automatically.
Re-labeling recordings
Follow the procedure of the “Labeling”
(page 44) to relabel a name.
Note
The recorder cannot rewrite a disc or track
name of more than 200 letters that was created
by another device.
For the remote control operations,
see page 66.
When labeling a
track
“: Name”
When labeling a
disc
“: Name”
Functions Operations
To select a
character
Press VOL + or
–.
To enter a letter Press ENTER.
To enter a name Press ENTER for 2
seconds or more.
To insert a blank
space before the
cursor
Press END
SEARCH and press
VOL + at the same
time.
To delete a letter Press END
SEARCH and press
VOL – at the same
time.
To switch capital
and small letters.
Press X.
To cancel
labeling.
Press x or MENU.
The cursor flashes.