Filter
Top Products
75
Messages
If the following error messages flash in the display window, check the chart below.
Error message Meaning/Remedy
AVLS • AVLS is set to “ON” so that the volume will not increase anymore.
, Set AVLS to “OFF” (page 57).
FULL • You tried to set the 21st bookmark.
, You can set up to 20 bookmarks. Set bookmarks within 20.
BLANK • An MD with no recording on it is inserted.
BUSY • You tried to operate the recorder while it was accessing the
recorded data.
, Wait until the message goes out (in rare cases, it may take a
few minutes).
CannotCHG • You tried to charge at a place where the temperature is too high.
, Charge the battery at a temperature of 5°C (+41°F) to +40°C
(+104°F).
Edit • The MD player is recording information (track start and end
position) from the memory to the disk.
, Wait until this process is completed. Do not expose the player
to physical shock, nor disrupt power supply.
ERROR • There is an internal malfunction in the system.
, Restart the operation by doing steps 1 to 3 on page 74. If the
message appears again, please consult your nearest Sony
dealer.
FULL • The remaining recording time on the disc is 12 seconds (stereo), 24
seconds (LP2 stereo or monaural), 36 seconds (LP4 stereo), or
less.
, Replace the disc.
• You tried to enter more than 200 letters to label a single track or
disc.
• You tried to enter a total of more than 1,700 letters for track or disc
names.
• You tried to create a 100th group.
, You can create only up to 99 groups on a disc. Keep the group
number within 99.
HiDCin • Voltage of the power supply is too high (The supplied AC power
adaptor or the recommended car battery cord is not used).
, Use the supplied AC power adaptor or the recommended car
battery cord.
HOLD • The recorder is locked.
, Slide HOLD against the arrow to unlock the recorder
(page 18).