Filter
Top Products
Tuner
13
GB
Other Operations
To improve tuner reception
When tuner reception is poor, set CD player
power off by CD power manage function.
CD power is factory set to on.
1 Press CD.
2 Press ?/1 to turn off the system.
3 Press ?/1 while holding x.
“CD POWER OFF” appears.
To set the CD power on
Repeat the procedure above and “CD POWER
ON” appears.
Note
When “CD POWER OFF” is selected, CD access time
is increased.
To change the AM tuning interval
(except for European model)
The AM tuning interval is factory-preset to
9 kHz (or 10 kHz for some areas). To change the
AM tuning interval, tune in any AM station first,
then turn off the system. While holding x, press
?/1. When you change the interval, all the AM
preset stations are erased. To reset the interval,
repeat the same procedure.
Note
You cannot change the AM tuning interval in the
Power Saving Mode.
Tips
• The preset stations are retained for half a day even if
you disconnect the power cord or if a power failure
occurs.
• To improve the reception, adjust the supplied
antennas or connect an external antenna.
You can listen to a radio station either by
selecting a preset station, or by manually tuning
in the station.
Use buttons on the CD player for the operation.
Listening to a preset station
— Preset Tuning
Preset radio stations in the tuner’s memory first
(see “Presetting radio stations” on page 12).
1 Press TUNER/BAND repeatedly to
select “FM” or “AM”.
2 Press TUNING MODE repeatedly until
“PRESET” appears.
3 Press ./> (or PRESET –/+ on the
remote) repeatedly to select the
desired preset station.
Listening to non-preset radio
station
— Manual Tuning
1 Press TUNER/BAND repeatedly to
select “FM” or “AM”.
2 Press TUNING MODE repeatedly until
“PRESET” and “AUTO” disappear.
3 Press m/M (or TUNING –/+ on the
remote) repeatedly to tune in the
desired station.
To Do this
Tune in a station
with a weak signal
Follow the procedure described
in “Manual tuning preset”
(page 12).
Set another station
to the existing
preset number
Start over from step 1. After
step 4, press ./> (or
PRESET –/+ on the remote)
repeatedly to select the preset
number you want to store the
other station.
Listening to the radio
Frequency
Preset number
continued