Filter
Top Products
Tuner
15
GB
To change the AM tuning interval
(except for European, Middle
Eastern and Philippine models)
The AM tuning interval is factory-preset to
9 kHz (or 10 kHz for some areas). To change the
AM tuning interval, tune in any AM station first,
then turn off the system. While holding ENTER
on the unit, press ?/1 on the unit. When you
change the interval, all the AM preset stations
are erased. To reset the interval, repeat the same
procedure.
Note
You cannot change the AM tuning interval in Power
Saving Mode.
Tips
• The preset stations are retained for about a day even
if you disconnect the power cord or if a power failure
occurs.
• To improve the reception, adjust the supplied
antennas or connect an external antenna.
You can listen to a radio station either by
selecting a preset station, or by manually tuning
in the station.
Listening to a preset station
— Preset Tuning
Preset radio stations in the tuner’s memory first
(see “Presetting radio stations” on page 14).
1 Press TUNER/BAND repeatedly to
select “FM” or “AM”.
2 Press PRESET –/+ (or . or > on
the unit) repeatedly to select the
desired preset station.
Listening to the radio
FrequencyPreset number
continued