Filter
Top Products
39
EN
DSP
Adjusting the volume of
the bass and treble
You can adjust the volume of the bass and
treble to best fit the acoustic characteristics
inside your car.
1 Press (SOURCE) to select a source (tuner,
CD, or MD).
2 Press (SOUND) repeatedly until “BAS” or
“TRE” appears.
3 Rotate the dial to adjust the volume.
After three seconds, the display returns to
the normal playback mode.
Adjusting the turn-over frequency
You can adjust the bass and treble turn-over
frequencies.
1 Press (SOURCE) to select a source (tuner,
CD, or MD).
2 Press (SOUND) for two seconds.
3 Press (SOUND) repeatedly until “BAS” or
“TRE” appears.
Bass adjusting mode
Treble adjusting mode
Tip
Each time you press (5) (n), the mode
changes between the turn-over frequency
adjusting mode and the bass and treble volume
adjusting mode.
Frequency (Hz)
Turn-over frequency
4 Rotate the dial to select the turn-over
frequency.
The turn-over frequencies change as
follows:
Bass:
198 Hz n 250 Hz n 314 Hz* n 396 Hz
Treble:
2.0 kHz n 3.1 kHz* n 4.0 kHz n 5.0 kHz
* Factory-set frequency
5 Press (SOUND) for two seconds.
The display returns to the normal playback
mode.
Listening to each
programme source in its
registered surround menu
— Last Sound Memory (LSM)
Each time you return to the same source, you
can hear the same surround effect registered
for that source, even after changing the
programme source or turning the unit off and
then on again.
Changing the line output
level
You can change the line output level if you
hear distortion or other noise.
1 Press (SHIFT), then press (3) (SET UP)
until “L.out” appears.
2 Press (5) ( n) to select the desired
setting (–10 dB or –16 dB).
3 Press (SHIFT).