Sony LBTGPX55 Speaker System User Manual


 
model name [LBT-GPX77/GPX55/MHC-GPX88/GPX77/GPX55/GPX33]
[4-449-052-13(1)] GB
26
GB
filename[D:\MASNI JOB
FOLDER\SO130010\GB\4449052131\4449052131\06BAS.fm]
masterpage:Left
2 Hold down ENTER and PHASER
for about 3 seconds.
“PAIR HISTORY” and “CLEAR”
appear in the display panel and all the
pairing information is erased.
Setting the Bluetooth
audio codecs
You can select the Bluetooth audio codecs
when the connected Bluetooth device
supports Advanced Audio Coding
(AAC).
1 Press OPTIONS on the unit.
2 Press / repeatedly to select
“BT AAC”, then press .
3 Press / repeatedly to select
“BT AAC ON” or “BT AAC OFF”.
BT AAC ON: Advanced Audio
Coding (AAC) is selected if the
Bluetooth device supports AAC.
BT AAC OFF: Sub Band Codec
(SBC) is selected.
Notes
You can enjoy high quality sound if the AAC
is selected. In case you cannot listen to AAC
sound from your device, select “BT AAC
OFF”.
If you change this setting while the system is
connected to a Bluetooth device, the
Bluetooth device will be disconnected. To
connect to the Bluetooth device, perform the
Bluetooth connection again.
Setting/Canceling
Bluetooth standby
mode
The system goes into Bluetooth standby
mode and waits for a Bluetooth
connection, even when the system is
turned off.
1 Press OPTIONS on the unit.
2 Press / repeatedly to select
“BT STANDBY”, then press .
3 Press / repeatedly to select
“STANDBY ON” or “STANDBY
OFF”.
4 Press ?/1 to turn off the system.
When Bluetooth standby mode is set to
on, the system will turn on
automatically when you establish the
Bluetooth connection from the
Bluetooth device.
Note
The system will not enter Bluetooth standby
mode if you erase the pairing information.