12
Tuner
Presetting radio stations
You can preset 20 stations for FM and 10
stations for AM.
1 Press TUNER/BAND repeatedly until
the band you want appears.
Each time you press this button, the band
changes as follows:
FM y AM
2 Press TUNING MODE repeatedly until
“AUTO” appears.
3 Press +/– until the frequency indication
starts to change.
Scanning stops when the system tunes in a
station. “TUNED” and “STEREO” (for a
stereo program) appear.
4 Press TUNER MEMORY.
The next available preset number flashes in
the display. The stations are stored from
preset number 1.
5 Press ENTER.
“COMPLETE” appears and the station is
stored.
6 Repeat steps 1 to 5 to store other
stations.
To tune in a station with a weak
signal
Press TUNING MODE repeatedly until
“MANUAL” appears in step 2, then press +/–
to tune in the station.
To set another station to the
existing preset number
Start over from step 1. After step 4, press +/– to
select the preset number you want to store for
another station.
You can add a new preset number after the last
preset number.
To erase the preset station
1 Hold down TUNER MEMORY until a preset
number appears.
2 Press +/– to select the preset number you
want to erase.
Select “ALL ERASE” when you want to
erase all the preset stations.
3 Press ENTER.
“COMPLETE” appears.
When you erase a preset number, the preset
number decreases by one and all preset
numbers following the erased one are
renumbered.
To change the AM tuning interval
(Except for the European and Middle
Eastern models)
The AM tuning interval is factory set to 9 kHz (10
kHz in some areas). To change the AM tuning
interval, tune in any AM station first, then turn off the
power. While holding down the ENTER button, turn
the power back on. When you change the interval,
AM preset stations will be erased. To reset the
interval, repeat the same procedure.
Tip
The preset stations are retained for half a day even if
you unplug the power cord or if a power failure
occurs.
Preset number
MHz
DOLBY NR
VOLUME
OFF
DOLBY NR
VOLUME
OFF
DOLBY NR
VOLUME
OFF