Filter
Top Products
8
Connecting
optional AV
components
To enhance your system, you can connect
optional components. Refer to the
instructions included with each component
for details.
Connecting audio
components
Connecting a turntable
Be sure to match the color of the plugs and
the connectors. To listen to the sound from
the connected turntable, press FUNCTION
repeatedly until “PHONO” appears.
Note
Using the turntable at high volume may cause
distortion or howling. This is often caused by the
bass sound from the speakers. The bass sound may
be picked up by the needle of the turntable, and
produce the distortion or howling. To avoid this, do
the following:
1Keep some distance between the speakers and the
turntable.
2Stop using the surround effect.
3Install the speakers or the turntable on a firm and
stable surface.
4Press DBFB repeatedly until “DBFB
”
disappears from the display (LBT-D390/G5500/
XB33/XB33K/XB50 only).
Press SUPER WOOFER repeatedly until the
indicator on this button goes off (except for LBT-
D390/G5500/XB33/XB33K/XB50).
To the audio output of the turntable
To tune in a station with a weak
signal
Press TUNING MODE repeatedly until
“MANUAL” appears in step 2, then press
TUNING +/– to tune in the station.
To change the preset number
Start over from step 1.
Note
The preset stations are canceled when you
disconnect the power cord or if a power failure
occurs for half a day.
Step 3: Presetting radio stations
(continued)