7
Step 3: Presetting
radio stations
You can preset up to 30 stations, 20 for FM
and 10 for AM.
1 Press POWER (I/u for LBT-D990/
XB30) to turn on the power.
2 Press TUNER/BAND repeatedly
until the band you want appears in
the display.
Each time you press this button, the
band changes as follows:
FM ˜ AM
3 Press TUNING MODE repeatedly
until “AUTO” appears in the
display.
4 Press TUNING +/–.
The frequency indication changes and
scanning stops when the system tunes in
a station. “TUNED” and “STEREO” (for
a stereo program) appear.
5 Press TUNER MEMORY.
A preset number flashes in the display.
6 Press TUNING +/– to select the
preset number you want.
7 Press ENTER/NEXT.
The station is stored.
8 Repeat steps 2 through 7 to store
other stations.
To tune in a station with a weak
signal
Press TUNING MODE repeatedly until
“MANUAL” appears in step 3, then press
TUNING +/– to tune in the station.
To change the preset number
Start over from step 1.
To change the AM tuning interval
(Except for the Middle Eastern model)
The AM tuning interval is factory-preset to 9 kHz
(10 kHz in some areas). To change the AM tuning
interval to 10 kHz (or 9 kHz), press TUNER/BAND
repeatedly until “AM” appears first, then turn off
the system. While holding down ENTER/NEXT,
turn the system back on. When you change the
interval, the AM preset stations will be erased. To
reset the interval, repeat the same procedure.
Note
The preset stations are canceled when you
disconnect the power cord or if a power failure
occurs for half a day.
LBT-D290/D590/G3300/XB3/XB3K/XB4/XB4K/XB30
LBT-D690/D990/XB600/XB6/XB6K
DISCALL
DOLBYNR
OFF
AUTO
TUNED
STEREO
MHz
S
DOLBYNR
OFF
TUNED
STEREOAUTO
ALL DISC S
MHz
LBT-D290/D590/G3300/XB3/XB3K/XB4/XB4K/XB30
DOLBYNR
OFF
TUNED
STEREOAUTO
ALL DISC S
LBT-D690/D990/XB600/XB6/XB6K
DISCALL
DOLBYNR
OFF
AUTO
TUNED
STEREO
S
LBT-D290/D590/G3300/XB3/XB3K/XB4/XB4K/XB30
LBT-D690/D990/XB600/XB6/XB6K
DOLBYNR
OFF
TUNED
STEREOAUTO
ALL DISC S
DISCALL
DOLBYNR
OFF
AUTO
TUNED
STEREO
S
4,6 23571