Filter
Top Products
23
US
Miscellaneous
Sound skips or has noise.
If there is a device nearby that generates electromagnetic waves
like a wireless LAN or an electronic oven in use, locate the system
apart from it.
If there is an obstacle between the Bar Speaker and the
subwoofer, move or remove it.
Locate the Bar Speaker and the subwoofer as close as possible.
Switch the wireless LAN frequency of any nearby Wi-Fi router or
personal computer to 2.4 GHz range.
Switch the LAN connection of the TV or Blu-ray Disc player from
wireless to wired.
REMOTE CONTROL
The remote control of this system does not function.
Point the remote control at the remote control sensor on the Bar
Speaker (refer to “Parts and controls” (page 24)).
Remove any obstacles in the path between the remote control
and the system.
Replace both batteries in the remote control with new ones, if they
are weak.
Make sure you are pressing the correct button on the remote control.
TV remote control does not work.
This problem might be solved by enabling the IR repeater function
(page 8).
OTHERS
The Control for HDMI function does not work properly.
Check the HDMI connection (refer to “Connection” in the supplied
Startup Guide).
Set up the Control for HDMI function on the TV. Refer to the
operating instructions supplied with the TV for TV setting.
Make sure that any equipment connected is compatible with
“BRAVIA” Sync.
Check the Control for HDMI settings on the connected equipment.
Refer to the operating instructions supplied with the connected
equipment.
If you connect/disconnect the AC power cord (mains lead), wait
more than 15 seconds before operating the system.
If you connect the audio output of video equipment with the
system, using a cable other than an HDMI cable, no sound may be
output because of “BRAVIA” Sync. In such a case, set “CTRL
(Control for HDMI)” to “OFF” (page 16) or connect the cable from
the audio output jack of the video equipment directly to the TV.
“PRTECT (protect)” appears on the display of the Bar Speaker.
Press the (on/standby) button to turn off the system. After the
lamp disappears, disconnect the AC power cord (mains lead) then
ensure nothing is obstructing the ventilation holes of the system.
Sensors of the TV do not work properly.
The Bar Speaker may block some sensors (such as the brightness sensor)
and the remote control receiver of your TV, or the “emitter for 3D glasses
(infrared transmission)” of a 3D TV that supports the infrared 3D glass
system. Move the Bar Speaker away from the TV within a range that allow
those parts to operate properly. For the locations of the sensors and remote
control receiver, refer to the operating instructions supplied with the TV.
If the system still does not operate properly, reset the system as
follows:
1 Press the (on/standby) button on the remote control to
turn the Bar Speaker on.
2 Press the MENU button on the remote control.
3 Press the (select) button repeatedly until “SYSTEM”
appears, then press the ENTER button.
4 Press the (select) button repeatedly until “SYS.RST”
appears, then press the ENTER button (page 17).
5 Press the ENTER button after displaying “START.”
“RESET” appears on the display, and the settings of the menu
and sound fields, etc. return to their initial statuses.
6 Disconnect the AC power cord (mains lead) after “RESET”
disappears from the display.
RESET