Filter
Top Products
22
US
BLUETOOTH
BLUETOOTH connection cannot be completed.
Make sure that the lamp (blue) of the Bar Speaker is lit (refer to
“Listening to the sound from BLUETOOTH devices” in the supplied
Startup Guide).
Make sure the BLUETOOTH device to be connected is turned on
and the BLUETOOTH function is enabled.
Bring this system and the BLUETOOTH device closer together.
Pair this system and the BLUETOOTH device again. You may need to
cancel the pairing with this system using your BLUETOOTH device first.
Set “BT PWR (BLUETOOTH power)” to “ON” if it is set to “OFF”
(page 16).
Pairing cannot be achieved.
Bring this system and the BLUETOOTH device closer together
(refer to “Listening to the sound from BLUETOOTH devices” in the
supplied Startup Guide).
Make sure this system is not receiving interference from a wireless
LAN equipment, other 2.4 GHz wireless devices, or a microwave
oven. If a device that generates electromagnetic radiation is
nearby, move the device away from this system.
No sound is output from the connected BLUETOOTH device.
Make sure that the lamp (blue) of the Bar Speaker is lit (refer to
“Listening to the sound from BLUETOOTH devices” in the supplied
Startup Guide).
Bring this system and the BLUETOOTH device closer together.
If a device that generates electromagnetic radiation, such as a
wireless LAN equipment, other BLUETOOTH devices, or a
microwave oven is nearby, move the device away from this system.
Remove any obstacle between this system and the BLUETOOTH
device or move this system away from the obstacle.
Reposition the connected BLUETOOTH device.
Switch the wireless LAN frequency of any nearby Wi-Fi router or
personal computer to 5 GHz range.
Increase the volume on the connected BLUETOOTH device.
The sound is not in sync with the image.
When you are watching movies, you may hear the sound with a
slight delay from the image.
WIRELESS SOUND
No sound is heard from the subwoofer.
Check that the AC power cord (mains lead) of the subwoofer is
connected properly. (Refer to “Turning on the system” in the
supplied Startup Guide.)
The on/standby lamp of the Bar Speaker does not light.
Check that the AC power cord (mains lead) of the subwoofer is
connected properly.
Press the (on/standby) button of the subwoofer to turn on
the power.
The on/standby lamp of the Bar Speaker flashes slowly in green or
lights in red.
Move the subwoofer to a location near the Bar Speaker so that
the on/standby lamp of the Bar Speaker lights in green.
Follow the steps in “Enabling the Secure Link function” (page 9).
Check the connection status of the wireless sound system with
the “LNK.CHK” of the menu (page 17).
The on/standby lamp of the Bar Speaker flashes quickly in green.
Consult your nearest Sony dealer.
The on/standby lamp of the Bar Speaker flashes in red.
Press the (on/standby) button of the subwoofer to turn
off the power and check whether the ventilation opening of
the subwoofer is blocked or not.
The subwoofer is designed for playback of bass sound. When the
input source does not contain much of bass sound, as is the case
with most TV programs, the bass sound may not be audible.
Press the SW VOL + button on the remote control to increase the
volume of the subwoofer (refer to “Parts and controls” (page 26)).
System status Lamp (blue) status
During BLUETOOTH pairing Flashes quickly
The system is attempting to connect
with a BLUETOOTH device
Flashes
The system has established
connection with a BLUETOOTH device
Lit
The system is in BLUETOOTH standby
mode (when the system is off)
Unlit