30
GB
AM tuner section
Tuning range
Models of area code CA
4)
: With 10-kHz tuning scale:
530 – 1710 kHz
With 9-kHz tuning scale:
531 – 1710 kHz
Models of area code E
4)
: With 10-kHz tuning scale:
530 – 1610 kHz
With 9-kHz tuning scale:
531 – 1602 kHz
Models of area code MX: 530 – 1610 kHz
Models of area code SP: 531 – 1602 kHz
Antenna Loop antenna
Intermediate frequency
450 kHz
Usable sensitivity 50 dB/m (at 1,000 kHz or
999 kHz)
S/N 54 dB (at 50 mV/m)
Harmonic distortion 0.5% (50 mV/m, 400 Hz)
Selectivity At 9 kHz: 35 dB
At 10 kHz: 40 dB
4) You can change the AM tuning scale to 9 kHz y
10 kHz. After tuning in any AM station, turn off
the receiver. Hold down the + button and press the
?/1 button. All preset stations will be erased when
you change the tuning scale. To reset the scale to
10 kHz (or 9 kHz), repeat the procedure.
General
Power requirements
Models of area code CA, MX:
120 V AC, 60 Hz
Models of area code E: 110 – 120 V AC,
50/60 Hz
Models of area code SP: 220 – 230 V AC,
50/60 Hz
Power consumption 98 W
Power consumption (during standby mode)
Models of area code CA, MX:
1.7 W
Models of area code SP: 1.9 W
Dimensions (w/h/d) 430 × 83 × 289 mm
including projecting parts
and controls
Mass (Approx.) 3.1 kg
The area code of the receiver you purchased is shown
on the lower portion of the rear panel.
4-XXX-XXX-XX AA (Area code)
Speaker Section
SS-MSP1 Front, center and surround speakers
Speaker system Full range, magnetically
shielded
Speaker units 8 cm cone type
Enclosure type Bass reflex
Rated impedance 8 ohms
Power handling capacity
(Maximum input power)
100 watts
Sensitivity level 85 dB (1 W, 1m)
Frequency range 160 Hz – 20, 000 Hz
Dimensions (w/h/d)
Approx. 92 × 133 × 115 mm
including front grille
Mass Approx. 1 kg
SA-WMSP1 subwoofer
System Speaker system
Active subwoofer,
magnetically shielded
Speaker unit Woofer: 20 cm cone type
Enclosure type Acoustically Loaded Bass
Reflex
Continuous RMS power output
(8 ohms, 20 – 250 Hz) 50 W
Reproduction frequency range
28 Hz – 200 Hz
High frequency cut-off frequency
150 Hz
Input LINE IN (input pin jack)
Power requirements
Models of area code CA, MX:
120 V AC, 60 Hz
Models of area code SP: 230 V AC, 50/60 Hz
Power consumption 50 W
Dimensions (w/h/d) 270 × 325 × 385 mm
including front panel
Mass (Approx.) 10 kg
Supplied accessories
FM wire antenna (1)
AM loop antenna (1)
Remote commander RM-U305S (1)
R6 (size-AA) batteries (2)
Speakers
• Front speakers (2)
• Center speaker (1)
• Surround speakers (2)
• Sub woofer (1)
Speaker cords (5)
Speaker foot pads (24)
Coaxial digital cord (1)
Monaural audio cord (1)
Design and specifications are subject to change
without notice.
Specifications (continued)