Filter
Top Products
Additional Information
48
Speaker Section
SS-MSP1 Front, center and rear
speakers
Speaker system
Full range, magnetically
shielded
Speaker units
8 cm cone type
Enclosure type
Bass reflex
Rated impedance
8 ohms
Power handling capacity (Maximum
input power)
100 watts
Sensitivity level
85 dB (1 W, 1m)
Frequency range
160 Hz - 20, 000 Hz
Dimensions (w/h/d)
Approx. 92 x 133 x
115mm including
front grille
Mass Approx. 1 kg
Specifications
SA-WMSP1 subwoofer
AUDIO POWER
SPECIFICATIONS
POWER OUTPUT AND
TOTAL HARMONIC
DISTORTION:
With 8 ohm loads, from 28
- 200 Hz; rated 50 watts,
minimum RMS power,
with no more than 0.8%
total harmonic distortion
from 250 milliwatts to
rated output (USA model
only).
System Speaker system
Active subwoofer,
magnetically
shielded
Speaker unit Woofer: 20 cm cone
type
Enclosure type Acoustically Loaded
Bass Reflex
Continuous RMS power output (8 ohms,
20 - 250 Hz
50 W
Reproduction frequency range
28 Hz - 200 Hz
High frequency cut-off frequency
150 Hz
Input
LINE IN (input pin jack)
General
Power requirements
Models of area code U,
CA
120 V AC, 60 Hz
Models of area code SP
230 V AC,
50/60 Hz
Models of area code AU
240 V AC, 50/60 Hz
Power consumptions
50 W
Dimensions (w/h/d)
Approx. 270 x 325 x 385
mm including front
panel
Mass Approx. 10 kg
Supplied accessories
See page 4.
For details on the area code of the
component you are using, see
page 3.
Design and specifications are subject
to change without notice.
The specification measured is under:
• 230 V AC, 50 Hz condition. (models
of area code SP)
• 240 V AC, 50 Hz condition. (models
of area code AU)