Filter
Top Products
15
Hooking Up and Setting Up the Speaker System
45°
90°
20°
A A
B
CC
45°
90°
20°
A A
B
CC
Multi Channel Surround Setup
For the best possible surround sound all speakers should
be the same distance from the listening position (A).
(However, this unit lets you to place the center speaker up
to 5 feet (1.5 meters) closer (B) and the surround speakers
up to 15 feet (4.5 meters) closer (C) to the listening
position. The front speakers can be placed from 3 to 40
feet (1.0 to 12.0 meters) from the listening position (A).)
You can place the surround speakers either behind you or
to the side, depending on the shape of your room (etc.).
Note
Do not place the center speaker farther away from the listening
position than the front speakers.
When placing surround speakers to your side
When placing the surround speakers behind you
Settings
SMALL
SMALL
SMALL
YES
Speakers
Front
Center
Rear
Woofer
Specifying the speaker parameters
For HT-DDW830, the speaker size and sub woofer
selection has been preset to MICRO SP. (Micro Satellite
Speaker) according to the supplied speaker system. If you
change the speaker system, choose NORM. SP. (Normal
Speaker) to adjust the speaker size and sub woofer
selection. When you choose MICRO SP., the speaker size
and the sub woofer selection has been configurated as
follows:
You cannot change the configuration if you choose MICRO SP.
The setting for Micro Satellite speaker (MICRO SP.) has been
programmed to optimize the sound balance. If you use Sony’s
Micro Satellite speakers, select MICRO SP. When you use Micro
Satellite speaker and the speaker size is set to LARGE, you may
not obtain the correct soundstage. The speaker may also be
damaged at high volume position.
1 Press ?/1 to turn on the receiver.
2 Press SET UP.
3 Press the cursor buttons ( or ) to select the
parameter you want to adjust.
4 Turn the jog dial to select the setting you want.
The setting is stored automatically.
5 Repeat steps 3 and 4 until you have set all of the
parameters that follow.
The following speaker size setup is applicable for
NORM. SP.