Filter
Top Products
29
GB
Additional Information
Switch the wireless LAN frequency
of any nearby Wi-Fi router or
personal computer to 5 GHz band.
Switch the TV, Blu-ray Disc player,
etc. from wireless LAN to wired LAN.
The remote control does not function.
Point the remote control at the
center of the front panel (remote
control sensor) of the system
(page 31).
Remove any obstacles in the path
between the remote control and the
system.
Replace both batteries in the
remote control with new ones, if
they are weak.
Make sure you are pressing the
correct button on the remote
control.
The TV remote control does not work.
Install the Bar Speaker so that it
does not obstruct the remote
control sensor of the TV.
The Control for HDMI function does not
work properly.
Check the HDMI connection (refer to
the supplied Startup Guide).
Set up the Control for HDMI function
on the TV. Refer to the operating
instructions supplied with the TV for
TV setting.
If you connect/disconnect the AC
power cord (mains lead), wait more
than 15 seconds before operating
the system.
Make sure that any device
connected is compatible with
“BRAVIA” Sync.
Check the Control for HDMI settings
on the connected device. Refer to
the operating instructions supplied
with the connected device.
If you connect the audio output of
video device with the system, using
a cable other than an HDMI cable,
no sound may be output because of
the Control for HDMI function. In
such a case, set [CTRL (Control for
HDMI)] in [HDMI] to [OFF] (page 17)
or connect the cable from the audio
output jack of the video device
directly to the TV.
The type and number of devices
that can be controlled by the
“BRAVIA” Sync feature is restricted
by HDMI CEC standard as follows:
– Recording devices (Blu-ray Disc
recorder, DVD recorder, etc.): up
to 3
– Playback devices (Blu-ray Disc
Player, DVD player, etc.): up to 3
– Tuner-related devices: up to 4
– Audio system (receiver/
headphone): up to 1 (including
this system)
No image is output from the TV when
the Bar Speaker is in standby mode.
Make sure [S. THRU] is set to [ON]
(page 17).
If [PRTECT (protect)] appears on the
front panel display of the Bar Speaker
Press the / (on/standby) button
on the Bar Speaker to turn off the
system. After the display stops
flashing, disconnect the AC power
cord (mains lead) then check that
nothing is blocking the ventilation
holes of the Bar Speaker.
The front panel display of the Bar
Speaker is not lit.
Press DIMMER to set the brightness
to bright or dark, if set to off
(page 34).
Remote control
Others