Sony DX60AV Stereo System User Manual


 
28
Troubleshooting
If you have any problem using this system, use
the following check list.
First, check that the power cord is connected
firmly and the speakers are connected correctly
and firmly.
Should any problem persist, consult your
nearest Sony dealer.
General
The display starts flashing as soon as you plug
in the power cord even though you havent
turned on the system (see step 5 of Hooking up
the system on page 7).
Press DISPLAY twice when the system is turned
off. The demonstration disappears.
The clock setting/radio presetting/timer is
canceled.
The power cord is disconnected or a power
failure occurs longer than half a day.
Redo the following:
—“Setting the time on page 9
—“Presetting radio stations on page 13
If you have set the timer, also redo Waking up
to music on page 23 and Timer-recording radio
programs on page 18.
There is no sound.
Turn VOLUME clockwise (or press VOL + on
the remote).
The headphones are connected.
Insert only the stripped portion of the speaker
cord into the SPEAKER jack. Inserting the vinyl
portion of the speaker cord will obstruct the
speaker connections.
There is no audio output during timer recording.
There is severe hum or noise.
A TV or VCR is placed too close to the stereo
system. Move the stereo system away from the
TV or VCR.
The sound from the connected source is
distorted.
If VIDEO appears in the display when you
press MD (VIDEO), switch the display to MD
(see Hooking up the optional A/V components
on page 24).
0:00 (or 12:00 AM) flashes in the display.
A power interruption occurred. Set the clock and
timer settings again.
The timer does not function.
Set the clock correctly.
DAILY 1, DAILY 2, and REC do not appear
when you press CLOCK/TIMER SET.
Set the timer correctly.
Set the clock.
The remote does not function.
There is an obstacle between the remote and the
system.
The remote is not pointing in the direction of the
systems sensor.
The batteries have run down. Replace the
batteries.
There is acoustic feedback.
Reduce the volume.
Move the microphone away from the speakers or
change the direction of the microphone.
The color irregularity on a TV screen persists.
Turn off the TV set once, then turn it on after 15
to 30 minutes. If the color irregularity still
persists, place the speakers farther away from the
TV set.
PROTECT and PUSH POWER appear
alternately.
A strong signal was input. Press ?/1 to turn off
the system, leave the system turned off for a
while, then press ?/1 again to turn on the
system. If PROTECT and PUSH POWER
appear alternately even after the system is turned
on again, press ?/1 to turn off the system and
check the speaker cord.