Filter
Top Products
23
Other Features
Waking up to music
— Daily Timer
You can wake up to music at a preset time.
Make sure you have set the clock (see “Setting
the time” on page 9).
1 Prepare the music source you want to
play.
• CD: Load a CD. To start from a
specific track, make a program (see
“Programing CD tracks” on page 11).
• Tape: Load a tape with the side you
want to play facing forward.
• Radio: Tune in the preset station you
want (see “Listening to the radio” on
page 14).
2 Adjust the volume.
3 Press CLOCK/TIMER SET on the
remote.
“SET DAILY 1” appears.
4 Press v or V repeatedly to select
“DAILY 1 (or 2)”, then press ENTER.
“ON” appears and the hour indication
flashes.
5 Set the time to start playing.
Press v or V repeatedly to set the hour,
then press B.
The minute indication flashes.
Press v or V repeatedly to set the minute,
then press ENTER.
6 Repeat step 5 to set the time to stop
playing.
7 Press v or V repeatedly until the music
source you want appears.
The indication changes as follows:
t
TUNER
y
CD PLAY
T
t
TAPE PLAY
T
8 Press ENTER.
The type of timer (“DAILY 1” or “DAILY
2”), followed by the start time, stop time,
and the music source, appear, then the
original display appears.
9 Press ?/1 to turn off the system.
To Do this
Check the setting Press CLOCK/TIMER
SELECT on the remote and
press v or V repeatedly to
select the respective mode
(“DAILY 1” or “DAILY 2”),
then press ENTER.
Change the setting Start over from step 1.
Cancel the timer Press CLOCK/TIMER
SELECT on the remote and
press v or V repeatedly to
select “TIMER OFF”, then
press ENTER.
Tip
The system turns on 15 seconds before the preset
time.
Notes
• You cannot activate DAILY 1 and DAILY 2 timer
at the same time.
• When you use the Sleep Timer, the Daily Timer
will not turn on the system until the Sleep Timer
turns it off.
• You cannot activate the Daily Timer and Timer-
recording at the same time.