Sony DAV-DZ560 Home Theater System User Manual


 
10
GB
Getting Started
Step 1: Assembling the Speakers
Before connecting the speakers, attach the speaker stand to the speaker.
(For the front speakers)
Use the parts as follows:
Front speakers (2)
Speaker cords (2, red/white)
Posts (2)
Bases (2)
Mounting plates (2)
Post covers (2)
Screws (large, with washer) (4)
Screws (small) (6)
About how to connect the speaker cords to the SPEAKER jacks, see page 19.
Note
• Spread a cloth on the floor to avoid damaging the floor when you assemble the speakers.
Ti
p
• You can use the speaker without the speaker stand by installing it on the wall (page 15).
1 Thread the speaker cord through the hole in the base and post.
The connector and color tube of the speaker cords are the same color as the label of the jacks to be
connected.
Use the speaker cords as follows:
Front speaker (L): White
Front speaker (R): Red
Be careful with the orientation of the post. Thread the speaker cord (and the speaker system cord)
into the end of the post that has two holes.
Speaker cord
Bottom of the base
,
Post
Two holes
Top of the base