Sony DAV-DZ231 Home Theater System User Manual


 
76
GB
On handling discs
To keep the disc clean, handle the disc by its
edge. Do not touch the surface.
Do not stick paper or tape on the disc.
Do not expose the disc to direct sunlight or
heat sources such as hot air ducts, or leave it in
a car parked in direct sunlight as the
temperature may rise considerably inside the
car.
After playing, store the disc in its case.
On cleaning
Before playing, clean the disc with a cleaning
cloth.
Wipe the disc from the center out.
Do not use solvents such as benzine, thinner,
commercially available cleaners, or anti-static
spray intended for vinyl LPs.
This system can only play back a standard
circular disc. Using neither standard nor circular
discs (e.g., card, heart, or star shape) may cause
a malfunction.
Do not use a disc that has a commercially
available accessory attached, such as a label or
ring.
If you experience any of the following
difficulties while using the system, use this
troubleshooting guide to help remedy the
problem before requesting repairs. Should any
problem persist, consult your nearest Sony
dealer.
Note that if service personnel changes some
parts during repair, these parts may be retained.
Power
The power is not turned on.
Check that the AC power cord (mains lead) is
connected securely.
•Press "/1 after “STANDBY” disappears from the
front panel display.
If “PROTECTOR” and “PUSH POWER” appear
alternately in the front panel display.
Press "/1 to turn off the system, and check the
following items after “STANDBY” disappears.
Are the + and – speaker cords short-circuited?
Are you using only the specified speakers?
Is anything blocking the ventilation holes of the
system?
After checking the above items and fixing any
problems, turn on the system. If the cause of the
problem cannot be found even after checking all the
above items, consult your nearest Sony dealer.
Picture
There is no picture.
The SCART (EURO AV) cord is not connected
securely.
The SCART (EURO AV) cord is damaged.
The unit is not connected to the correct
EURO AV t INPUT jack (page 9).
The video input on the TV is not set so that you
can view pictures from the system.
Check the output method on your system
(page 16).
Re-connect the connecting cord securely.
The unit is connected to an input device that is not
HDCP (high-bandwidth digital content
protection) compliant (“HDMI” on the front panel
does not light up). See page 87.
If the HDMI OUT jack is used for video output,
changing the type of video signal output from the
HDMI OUT jack by pressing VIDEO FORMAT
may solve the problem (page 20).
Connect the TV and the unit using a video jack
Notes about the Discs Troubleshooting