Filter
Top Products
I
1
2
3
1
■
3
II
2
<
.
The clock is displayed. (The “:”
between the hours and minutes
flashes,) When the power cord is plugged into an AC outlet
for the first time after purchase or when the clock setting is
canceled due to a power failure, the entire clock display
flashes.
Press CLOCK.
When using the remote control, press CLOCK while pressing
SHIFT.
Within 4 seconds, turn MULTI JOG to designate
the hour and the minute.
Turning MULTI JOG changes both the hour and the minute.
< or
➤- ie also available instead of MULTI JOG, Holding
these buttons down will vary the time rapidly.
Press ENTER or El,
The clock starts from 00 seconds,
To restore an original clock setting
Press CLOCK before completing step 3 to restore the previous
time setting, This cancels any new setting,
To view the clook when another diepiay ia in the dlepiay
Press CLOCK. The time is displayed for 4 seconds and then the
original display reappears, However, the clock cannot be
displayed during recording,
To ewHch to the 24-hour standard
Press the CLOCK and then press
■ within 4 seconds.
Repeat the came procedure to reetor.s the 12-hour standard.
If the clock diepiay fiaahea
This is caused by a power interruption. The current time needs
to be reset,
If power is interrupted for more than approximately 24 hours,
all settings stored in memory after purchase need to be reset.
.-.,. ........ ... ,-
The unit can be turned off automatically at a specified time,
Use the remote control.
1
Press SLEEP while pressing SHIFT.
2 Within 4 seconds, turn MULTI JOG to specify the
time until the power is turned off,
The time changes between 5 and 240 minutes in 5-minute
steps,
44 and * are also available instead of MULTI JOG.
Specified time
To check the time remaining untii the power Is turned off
Press SLEEP once while preseing SHIFT, The remaining time ie
displayed for 4 seconds.
To cancel the sleep timer
Press SLEEP twice whiie pressing SHIFT so that “SLEEP oFF”
appeare on the dieplay,
If the power-economizing mode (page 7) is on, all the display
iights turn off when the power is turned off. TOview the clock,
press CLOCK so that the time is displayed for 4 seconds,
26 ENGLISH