Filter
Top Products
27
GB
Others
CMT-U1BT.GB.2-683-494-61(1)
To improve tuner reception
Turn o CD player power by using the CD
power management function. By default, CD
power is turned on. You cannot change the
setting in Power Saving Mode.
Use buttons on the unit to turn o CD player
power.
1
Press FUNCTION
repeatedly to select
the CD function, and then turn off the
system.
2
After “STANDBY” stops flashing, press /
while holding down
.
“CD POWER OFF” appears. With CD
player power turned o, disc access time
is increased. To turn on CD player power,
repeat the procedure until “CD POWER
ON” appears.
To reset the system to factory settings
If the system still does not operate properly,
reset the system to factory settings. You cannot
reset the system to factory settings in Power
Saving Mode. Use buttons on the unit to reset
the system to its factory default settings.
1
Disconnect and reconnect the power cord,
and then turn on the system.
2
Press DSGX
and /
at the same
time.
All user-congured settings, such as preset
radio stations, timer, and the clock, are
deleted.
Messages
CD/ATRAC/MP3 player, Tuner
Complete!: e preset operation ended
normally.
LOCKED: e system does not eject the disc.
Contact your nearest Sony dealer.
No Disc: ere is no disc in the system, or you
have loaded a disc that cannot be played.
No Step: All of the programmed tracks or les
have been erased.
Not in Use: You pressed an invalid button.
OFF TIME NG!: e Play Timer start and end
times are set to the same time.
Over: You have reached the end of the disc
while pressing
during playback or
pause.
Push SELECT!: You tried to set the clock or
timer during timer operation.
Push STOP!: You pressed PLAY MODE
during playback.
Reading: e system is reading information of
the disc. Some buttons are not available.
SET CLOCK!: You tried to select the timer when
the clock is not set.
SET TIMER!: You tried to select the timer when
the Play Timer is not set.
Step Full!: You tried to program more than 26
tracks or les (steps).
Continued