Filter
Top Products
CD – Play
9
GB
Use buttons on the remote for the operation.
1 Press ?/1 to turn on the unit.
2 Press CLOCK/TIMER SET.
3 Press . or > repeatedly to set the
hour.
4 Press ENTER.
5 Press . or > repeatedly to set the
minute.
6 Press ENTER.
The clock starts working.
To adjust the clock
1 Press CLOCK/TIMER SET.
2 Press . or > repeatedly to select
“CLOCK SET”, then press ENTER.
3 Do the same procedures as step 3 to 6
above.
Note
The clock is not displayed in Power Saving Mode
(page 23).
1 Press CD (or FUNCTION repeatedly on
the unit) to switch the function to CD.
2 Insert a disc in the disc slot with the
label side up.
Notes
• When you turn on the system, the disc is not
pulled into the disc slot until “NO DISC”
appears in the display. Do not attempt to
push in the disc until “NO DISC” appears.
• Do not use a disc with tape, seals or paste on it as this
may cause malfunction.
• Do not load an 8 cm disc with an adaptor. Doing so
may cause the system to malfunction.
• When you remove a disc, handle the disc by its edge
and pull it straight out of the disc slot. Do not touch
the surface.
• If you load a disc that is not playable by this system,
it will be ejected automatically.
Setting the clock
CD – Play
Loading a disc
.
mM
>
N
X
x
Z
When you
play a disc,
insert it with
the label side
up.