Filter
Top Products
CMT-DH3.GB.3-097-194-11(1)
19
GB
Getting Started
Power
Connect the power cord to a wall socket.
If the supplied adaptor on the plug does
not t your wall socket, detach it from
the plug (only for models equipped with
an adaptor).
Inserting two R6 (size AA)
batteries into the remote
Slide and remove the battery
compartment lid, and insert the two
supplied R6 (size AA) batteries, side
rst, matching the polarities shown
below.
Note
If you do not use the remote for a long period
of time, remove the batteries to avoid possible
damage from battery leakage and corrosion.
Tip
With normal use, the batteries should last for
about six months. When the remote no longer
operates the system, replace both batteries with
new ones.
Attaching the speaker pads
Attach the supplied speaker pads at each
corner on the bottom of the speakers
to stabilize the speakers and to prevent
them from slipping.
When carrying this system
Perform the following procedure to
protect the DVD mechanism.
Use buttons on the unit for the
operation.
1
Press /
to turn on the
system, then press DVD
.
2
Make sure that no disc is loaded
in the system and check that “No
Disc” appears.
3
Press /
to turn o the
system and check that “STANDBY”
disappears.
4
Unplug the power cord.