Filter
Top Products
12
GB
To change the AM tuning interval
(except for European models)
The AM tuning interval is factory-preset to
9 kHz (or 10 kHz for some areas). To change the
AM tuning interval, tune in any AM station first,
then turn off the system. While holding
TUNING +, press ?/1 on the unit. When you
change the interval, all the AM preset stations
are erased. To reset the interval, repeat the same
procedure.
Note
You cannot change the AM tuning interval in Power
Saving Mode.
Tips
• The preset stations are retained for about half a day
even if you disconnect the mains lead or if a power
failure occurs.
• To improve the reception, adjust the supplied
antennas or connect an external antenna.
To improve tuner reception
When tuner reception is poor, set CD player
power off by the CD power manage function.
CD power is factory set to on.
1 Press FUNCTION repeatedly to switch the
function to CD.
2 Press ?/1 to turn off the system.
3 Press ?/1 on the unit while holding CD x on
the unit.
“CD POWER” and “OFF” appear.
To set the CD power on
Repeat the procedure above, and “CD POWER”
and “ON” appear.
Notes
• When “CD POWER” and “OFF” are selected, CD
access time is increased.
• In Power Saving Mode, switching the CD power on
or off using the CD power manage function is not
possible.
You can listen to a radio station either by
selecting a preset station, or by manually tuning
in the station.
Listening to a preset station
— Preset Tuning
Preset radio stations in the tuner’s memory first
(see “Presetting radio stations” on page 11).
1 Press TUNER/BAND repeatedly to
select “FM” or “AM”.
2 Press TUNING MODE repeatedly until
“PRESET” appears in the display.
3 Press +/– (or turn TUNING +/– on the
unit) repeatedly to select the desired
preset station.
Listening to non-preset radio
station
— Manual Tuning
1 Press TUNER/BAND repeatedly to
select “FM” or “AM”.
2 Press TUNING MODE repeatedly until
“AUTO” and “PRESET” disappear from
the display.
3 Press +/– (or turn TUNING +/– on the
unit) repeatedly to tune in the desired
station.
Tips
• To improve broadcast reception, adjust the supplied
antennas, or connect a commercially available
external antenna.
• When an FM stereo program has static noise, press
FM MODE repeatedly until “MONO” appears.
There will be no stereo effect, but the reception will
improve.
• Press TUNING MODE repeatedly until “AUTO”
appears in step 2 above, then press +/– (or turn
TUNING +/– on the unit). The frequency indication
changes and scanning stops when the system tunes in
a station (Automatic Tuning).
• To record the radio programs, use manual recording
(pages 16 and 18).
Listening to the radio