Filter
Top Products
34
Error displays/Messages
*1 When the CD/MD changer is connected to the unit,
the disc number of the CD or MD appears in the
display.
*2 The disc number of the disc causing the error
appears in the display.
Radio reception
Preset tuning is not possible.
• Store the correct frequency in the memory.
• The broadcast signal is too weak.
The stations cannot be received.
The sound is hampered by noises.
• Connect a power antenna control lead (blue)
or accessory power supply lead (red) to the
power supply lead of a car’s antenna booster.
(Only if your car has a built-in FM/AM
antenna in the rear/side glass.)
• Check the connection of the car antenna.
• The auto antenna will not go up.
tCheck the connection of the power
antenna control lead.
• Check the frequency.
• When the DSO mode is on, the sound is
sometimes hampered by noises.
tSet the DSO mode to “OFF” (page 26).
Automatic tuning is not possible.
• The local seek mode is set to “ON.”
tSet the local seek mode to “OFF”
(page 25).
• The broadcast signal is too weak.
tPerform manual tuning.
The “STEREO” indication flashes.
• Tune in the frequency accurately.
• The broadcast signal is too weak.
tSet to the monaural reception mode
(page 25).
A program broadcast in stereo is heard in
monaural.
The unit is in monaural reception mode.
tCancel monaural reception mode
(page 25).
Interference occurs during FM reception.
The wide mode is selected.
tSet the IF mode to “IF AUTO” (page 25).
Error displays
(For this unit and optional CD/MD changers)
The following indications will flash for about
5 seconds, and an alarm sound will be heard.
Blank*
1
No tracks have been recorded on an MD*
2
.
tPlay an MD with recorded tracks on it.
Error*
1
• A CD is dirty or inserted upside down.*
2
tClean or insert the CD correctly.
• A CD/MD cannot play because of some
problem.*
2
tInsert another CD/MD.
High Temp
The ambient temperature is more than 50°C
(122°F).
tWait until the temperature goes down
below 50°C (122°F).
NO Disc
No disc is inserted in the CD/MD unit.
tInsert discs in the CD/MD unit.
NO Magazine
The disc magazine is not inserted in the CD/
MD unit.
tInsert the magazine in the CD/MD unit.
NO Music*
1
A CD which is not a music file is inserted.
tInsert a music CD.
Not Ready
The lid of the MD unit (MDX-40) is open or
the MDs are not inserted properly.
tClose the lid or insert the MDs properly.
Push Reset
The CD/MD unit cannot be operated because
of some problem.
tPress the reset button on the unit.