Filter
Top Products
14
Other functions
Changing the sound settings
Adjusting the sound
characteristics — Balance/Fader/
Sub Woofer
You can adjust the balance, fader and subwoofer
volume.
1 Select a source, then press (SOUND)
repeatedly to select the desired item.
The item changes as follows:
HDEQ t DSO 3D t I-TA t
Balance (left-right) t
Fader (rear-front) t
Sub Woofer (subwoofer volume)*
* “ – ∞” is displayed at the lowest setting, and can
be adjusted up to 20 steps.
2 Rotate the VOL control dial to adjust
the selected item.
After about 3 seconds, the setting is complete
and the display returns to normal play/
reception mode.
With the card remote commander
In step 2, to adjust the selected item, press < or ,.
Adjusting menu items — MENU
1 Press (MENU).
2 Rotate the SEEK control dial until the
desired menu item appears, then
press (ENTER).
The items changes as follows:
SETUP y DISPLAY y RECEIVE
MODE y SOUND y LIST
3 Rotate the SEEK control dial until
desired setting item appears, then
press (ENTER).
The digital indication moves to the right
(setting selection) side.
4 Rotate the SEEK control dial to select
the setting, then press (ENTER).
The setting is complete.
5 Press (MENU).
The display returns to normal play/reception
mode.
Note
Displayed items will differ, depending on the source
and setting.
With the card remote commander
In steps 2 and 3: press M or m instead of the SEEK
control dial; in steps 2, 3 and 4, press < or ,
instead of (ENTER).
The following items can be set (follow the page
reference for details):
“
z” indicates the default settings.
SETUP
DISPLAY
Clock Adjust (page 4)
Beep
To set “on” (z) or “off.”
RM (Rotary Commander)
To change the operative direction of the rotary
commander controls.
– “REV”: when you mount the rotary
commander on the right side of the steering
column.
–“NORM” (
z): to use the rotary commander in
the factory-set position.
AUX-Audio*
1
To turn the AUX source display “on” (z) or
“off” (page 16).
Auto Image
Auto Image mode automatically steps (every 10
seconds) through the display images.
– “off”: to not change the image automatically.
– “SA”: to step repeatedly through the display
images of Spectrum analyzer mode.
– “Movie”: to step repeatedly through the
display images of Movie mode.
–“All” (
z): to step repeatedly through the
display images in all display modes.
Information (Display Information)
To display the items (depending on the source,
etc.) at the middle of the display while a image
is displayed.
–“Simple”(
z): to not display any items.
– “All”: to display all items.
– “Clear”: to have items automatically
disappear. (Excluding digital indication.)
Demo*
1
(Demonstration)
To set “off” or “on” (z).
Dimmer
To change the brightness of the display.
–“Auto” (
z): to dim the display automatically
when you turn lights on.
– “on”: to dim the display.
– “off”: to deactivate the dimmer.