Filter
Top Products
29
Error displays/Messages
Radio reception
Preset tuning is not possible.
• Store the correct frequency in the memory.
• The broadcast signal is too weak.
The stations cannot be received.
The sound is hampered by noises.
• Connect a power antenna control lead (blue)
or accessory power supply lead (red) to the
power supply lead of a car’s antenna booster
(only when your car has built-in FM/AM
antenna in the rear/side glass).
• Check the connection of the car antenna.
• The auto antenna will not go up.
tCheck the connection of the power
antenna control lead.
• Check the frequency.
• When the DSO mode is on, the sound is
sometimes hampered by noises.
tSet the DSO mode to “OFF” (page 23).
Automatic tuning is not possible.
• The local seek mode is set to “ON.”
tSet the local seek mode to “OFF”
(page 22).
• The broadcast signal is too weak.
tPerform manual tuning.
The “ST” indication flashes.
• Tune in the frequency accurately.
• The broadcast signal is too weak.
tSet the monaural reception mode to
“ON” (page 22).
A program broadcast in stereo is heard in
monaural.
The unit is in monaural reception mode.
tCancel monaural reception mode
(page 22).
Interference occurs during FM reception.
The wide mode is selected.
tSet the IF mode to “IF AUTO” (page 22).
Error displays
(For this unit and optional CD/MD changers)
The following indications will flash for about
5 seconds, and an alarm sound will be heard.
BLANK*
1
No tracks have been recorded on an MD.*
2
tPlay an MD with recorded tracks on it.
ERROR*
1
• A CD is dirty or inserted upside down.*
2
tClean or insert the CD correctly.
• A CD/MD cannot play because of some
problem.
tInsert another CD/MD.
FAILURE (Illuminates until any button is
pressed.)
The connection of speakers/amplifiers is
incorrect.
tSee the installation guide manual of this
model to check the connection.
FAILURE (Illuminates for about 1 second.)
When the XM tuner is connected, storing an
XM radio channel into a preset failed.
tBe sure to receive the channel that you
want to store, then try it again.
HI TEMP
The ambient temperature is more than 50°C
(122°F).
tWait until the temperature goes down
below 50°C (122°F).
NO DISC
No disc is inserted in the CD/MD unit.
tInsert discs in the CD/MD unit.
NO MAG
The disc magazine is not inserted in the CD
unit.
tInsert the magazine in the CD unit.
NO MUSIC
A CD which is not a music file is inserted in
the MP3 playable CD unit.
tInsert a music CD in the MP3 playable CD
unit.
NOTREADY
The lid of the MD unit is open or the MDs are
not inserted properly.
tClose the lid or insert the MDs properly.
OFFSET
There may be an internal malfunction.
tCheck the connection. If the error
indication remains on in the display,
consult your nearest Sony dealer.
continue to next page t