Filter
Top Products
24
Setting the Dynamic
Soundstage Organizer (DSO)
If your speakers are installed into the lower part
of the doors, the sound will come from below
and may not be clear.
The DSO (Dynamic Soundstage Organizer)
function creates a more ambient sound as if there
were speakers above the dashboard (virtual
speakers).
You can store the DSO setting for each source.
DSO mode and image of virtual speakers
*1 DSO 1
*2 DSO 2
*3 DSO 3
*4 DSO OFF
1 Press (SOURCE) to select a desired
source.
2 Press (DSO) repeatedly until the
desired DSO setting appears.
Each time you press (DSO), the DSO setting
changes “DSO········1-3,” and “off.”
To cancel the DSO function, select
“DSO······off.” After 3 seconds, the display
returns to the normal playback mode.
Notes
• Depending on the type of car interior or type of
music, DSO may not have a desirable affect.
• If FM broadcasts are difficult to hear, set DSO to off.
Adjusting the front and rear
volume
1 Press (SOURCE) to select a desired
source.
2 Press (SOUND) repeatedly until “FAD”
appears.
3 Press < or , repeatedly to adjust
the volume of front/rear speakers.
After 3 seconds, the display returns to the
normal playback mode.
Adjusting the cut-off frequency for the
front/rear speakers
To match the characteristics of the installed
speaker system, you can select the cut-off
frequency of the speakers.
1 During playback or radio reception,
press (MENU).
2 Press M or m repeatedly until “HPF”
appears.
3 Press < or , to select the cut-off
frequency.
Each time you press < or ,, the frequency
changes as follows:
off (default setting) y 78Hz y 125Hz
4 Press (MENU).
After the frequency setting is complete, the
display returns to normal playback mode.
*1
*1
*4
*3
*2
*3
*2
*4
Cut-off frequency
Frequency (Hz)
Level
off