Filter
Top Products
23
Error displays/Messages
Error displays
The following indications will flash for about
5 seconds, and an alarm sound will be heard.
ERROR*
1
•A CD is dirty or inserted upside down.
tClean or insert the CD correctly*
2
.
•
A CD cannot play because of some problem.
tInsert another CD*
2
.
HI TEMP
The ambient temperature is more than 50°C.
tWait until the temperature goes down
below 50°C.
NO DISC
No disc is inserted in the CD unit.
tInsert discs in the CD unit.
RESET
The CD unit cannot be operated because of
some problem.
tPress the RESET button on the unit.
If these solutions do not help improve the
situation, consult your nearest Sony dealer.
Messages
L.SEEK +/–
The Local Seek mode is on during automatic
tuning (page 10).
NO AF
There is no alternative frequency for the
current station.
“ ” or “ ”
You have reached the beginning or the end
of the disc and you cannot go any further.
*
1
When an error occurs during playback of a CD,
the disc number of the CD does not appear in
the display.
*
2
The disc number of the disc causing the error
appears in the display.
Radio reception
Preset tuning is not possible.
•Store the correct frequency in the memory.
•The broadcast signal is too weak.
The stations cannot be received.
The sound is hampered by noises.
•Connect a power aerial control lead (blue)
or accessory power supply lead (red) to the
power supply lead of a car’s aerial booster.
(Only when your car has built-in FM/
MW/LW aerial in the rear/side glass.)
•Check the connection of the car aerial.
•The auto aerial will not go up.
t Check the connection of the power
aerial control lead.
•Check the frequency.
Automatic tuning is not possible.
•The local seek mode is set to “ON.”
t Set the local seek mode to “OFF” (page
10).
•The broadcast signal is too weak.
t Perform manual tuning.
The “ST” indication flashes.
•Tune in the frequency accurately.
•The broadcast signal is too weak.
t Set to the monaural reception mode
(page 10).
A programme broadcast in stereo is heard
in monaural.
The unit is in monaural reception mode.
tCancel monaural reception mode (page
10).
RDS
The SEEK starts after a few seconds of
listening.
The station is non-TP or has weak signal.
tPress (AF) or (TA) repeatedly until “AF-
OFF” or “TA-OFF” appears.
No traffic announcements.
•Activate “TA.”
•The station does not broadcast any traffic
announcements despite being TP.
t Tune in another station.
PTY displays “--------.”
•The current station is not an RDS station.
•RDS data has not been received.
•The station does not specify the
programme type.