Filter
Top Products
1
49
50
Red Edge
F.GND
AUDIO OUT
L GND R
0 1 2
INTERFACE CONNECTOR
DC INPUT
5V±5% GND 12V±10%
TEST MODE
PREVENT/ALLOW
ID SELECT
DEVICE TYPE
1
2
49
50
Sony CDU926S Drive
Power
Supply
Cable
Red Edge
SCSI Card
(Not included)
Speakers
(Not included)
Sound Card
(Not included)
Audio Cable
SCSI
Cable
(Not included)
Host Adapter Installation
Connect the free end of the flat cable to the existing SCSI host adapter
card and install the host adapter in the computer by inserting it securely in
a system expansion slot. Refer to the operating instructions of the host
adapter for complete instructions on its installation and the assignment of
its switches.
Notes
●
The red edge of the flat cable must be closest to pin number 1 of the
interface card connector.
●
The following illustration is a sample system configuration of the
Sony CDU926S CD-R drive installation with a SCSI card.
Installing the Drive Unit into the Computer 15
2 Locate an available power supply cable inside your computer and
connect it to the power supply connector on the rear of the CD-R drive
as shown.
Caution: Improper connection may damage the drive and void the warranty.
■ Frame ground
When normally installed, the drive unit is not in contact with the host
computer directly and should be grounded. Connect the frame ground tab
to one of the host computer’s ground cables.
The frame ground cable recommended has a AMP 1-480435-0 housing and
170203-2 or 60711-1 contacts.
14 Installing the Drive Unit into the Computer
Frame ground tab
Frame ground
cable
5V - 5%
GND
PARITY
2
ID SELECT
PREVENT/ALLOW
TEST MODE
INTERFACE CONNECTOR
DC INPUT
12V - 10%
+
+
DC INPUT
GND
12V 10%
5V 5%
+
-
+
-
Power Supply
Connector
Power Supply Cable