Filter
Top Products
Additional Information
20
EN
Troubleshooting
If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There’s no sound.
/Check that the player is connected securely.
/Make sure you operate the connected
component correctly.
/Adjust the playback level using the PHONE
LEVEL control.
The CD does not play.
/There’s no CD inside the player (“-NO DISC-”
appears). Insert a CD.
/Place the CD with the label side up on the disc
tray correctly.
/Clean the CD (see page 19).
/Moisture has condensed inside the player.
Remove the disc and leave the player turned on
for about an hour (see page 19).
The remote commander does not function.
/Remove the obstacles in the path of the remote
commander and the player.
/Point the remote commander at the remote
sensor in the left of the display on the player.
/Replace all the batteries in the remote
commander with new ones if they are weak.
/Set the Remote Protect of menu options to “RM
ENABLE” (see page 18).
The controls on the player do not function.
/Set the Key Protect of menu options to “LOCAL
ON” (see page 18).
The player functions incorrectly.
/The microcomputer chips may be operating
incorrectly. Turn off the player and turn it on
again.
Specifications
Compact disc player
Frequency response 5 Hz to 20 kHz ± 0.3 dB (at 10 kilohms)
Signal-to-noise ratio More than 100 dB (20 kHz LPF, IHF-A
weight)
Dynamic range More than 98 dB
Harmonic distortion Less than 0.004% (1 kHz, 0 dB, 20 kHz
LPF)
Channel separation More than 100 dB (1 kHz, 20 kHz LPF)
Analog outputs
Connector
ANALOG OUT
(BALANCE)
ANALOG OUT
(UNBALANCE)
PHONES
Digital outputs
Connector
DIGITAL OUT
(AES/EBU)
DIGITAL OUT
(IEC-958)
Word input
Connector
EXT SYNC
INPUT
Type
XLR-3
Phono
jacks
Stereo
phone jack
Output
impedance
100 ohms
200 ohms
150 ohms
Maximum
output level
+24 dBs
+ 9 dBs
15 mW
Load
impedance
More than
10 kilohms
More than
10 kilohms
32 ohms
Type
XLR-3
Phono jacks
Load
impedance
110 ohms
75 ohms
Output
impedance
50 ohms
(balanced)
75 ohms
(unbalanced)
Type
BNC
Input level
2 V p-p
(TTL
level)
Input
frequency
44.1 kH
±12.5%
Input
impedance
22 kilohms/
75 ohms,
switchable