Sony CDP-CX55 CD Player User Manual


 
Playing CDsGetting Started
21
Playing CDs
·
X-FADE
NO DELAY
Playing Alternately (No-Delay
Play/X-Fade Play)
When you connect the second player, you can play
tracks in this player and those in the second player
alternately in any play mode (see “Connecting Another
CD Player” on page 6).
Select one of the following methods:
No-Delay Play: The current player changes at each
track. Each time the current player changes to the
other player, the other player starts play without a
break in sound immediately after the current player
ends play. The other player skips the lead-in portion
and starts playing from where the sound actually
begins.
X-Fade Play: The current player changes at each
track or at the specified interval. You can select the
interval among 30, 60 and 90 seconds. Each time the
current player changes to the other player, the sound
from both players is mixed. The current player ends
play by fading out, and the other player starts play
by fading in.
1 Select the play mode you want on each player.
2 When you select No-Delay Play
Press NO DELAY.
“NO DELAY” appears in the display.
When you select X-Fade Play
Press X-FADE.
“X-FADE” appears in the display.
Each time you press the X-FADE button, the
indication appears as follows:
n FULL n 30 n 60 n 90 n OFF
To change the current player each time a whole
track is finished, select “FULL.”
To change the current player at the specified
interval, press X-FADE repeatedly until the
interval you want appears in the display.
3 Press · to start playing.
The MEGA CONTROL button lights up while the
track in the second player is selected.
To cancel No-Delay/X-Fade Play
Press the corresponding button repeatedly until “NO
DELAY” or “X-FADE” disappears from the display. The
current player continues playing.
You can change the method (No-Delay or X-Fade)
during play
Press the corresponding button (NO DELAY or X-FADE)
following the procedure in Step 2 above.
Notes
The play starts from the second player if you start play
while the MEGA CONTROL button is lit.
When one player has played all the discs/tracks in the
player ahead of the other player, the play stops.
Do not use the controls on the second player during
No-Delay/X-Fade Play. They may not work correctly.
2 Select the play mode you want.
To program tracks, use the controls on the second
player.
3 Press · on this player to start playing.
The play starts and the display shows the current
disc and track numbers and the playing time of the
track.
While the MEGA CONTROL button is lit, you can
control the second player with the controls on this
player.
To control the second player directly using the supplied
remote
Set CD 1/2/3 on the remote to CD 3 which is the same
position as the COMMAND MODE selector on the rear panel
of the second player.
To control this player again
Press MEGA CONTROL. The MEGA CONTROL button goes
off and you can control this player.