Filter
Top Products
18
Playing CDs
The programs remain even after Program Play ends
When you press ·, you can play the same program
again.
When you press PROGRAM during Continuous or
Shuffle Play
The program will be played after the current track.
The programs remain until you erase them
If you replace discs, the programmed disc and track
numbers remain. So, the player plays only the existing
disc and track numbers. However, the disc and track
numbers that are not found in the player or on the disc
are deleted from the program, and the rest of the
program is played in the programmed order.
Creating a program using the remote Z
3
Press the number button of the disc.
>10
DISC
CHECK
·
PROGRAM
Number
buttons
ENTER
CLEAR
1 Press PROGRAM until the program number you
want (PROGRAM 1, 2 or 3) appears in the display.
2 Press DISC.
4 To program a whole disc, skip this step and go to
Step 6. Press >10.
5 Press the number button of the track.
The number you pressed is entered into the
flashing digit.
7 To program other discs/tracks, do the following:
To program
Other discs
Other tracks on the same disc
Other tracks on other discs
8 Press · to start Program Play.
To cancel Program Play
Press CONTINUE.
Checking the programmed order
You can check your program before or after you start
playing.
Press CHECK.
Each time you press this button, the display shows the
disc and track number of each step in the programmed
order. (When a whole disc is programmed as one step,
“ALL” appears instead of the track number.) After the
last step in the program, the display shows “END” and
returns to the original display.
Repeat Steps
2, 3 and 6
4 to 6
2 to 6
6 Press ENTER.
The disc being programmed
The track being
programmed
Playing order
CD1
PROGRAM1
DISC-[ _]
2O
CD1
PROGRAM1
DISC-[ 2O]
2O
CD1
PROGRAM1
DISC
TRACK STEP
2O -- 1
2O
CD1
PROGRAM1
DISC
TRACK STEP
2O 3 1
2O
CD1
PROGRAM1
DISC
TRACK STEP
2O 3 1
2O