Filter
Top Products
Recording From CDs
19
EN
You can programme the tracks you want in advance
Select the tracks before doing the above procedure. The
player creates a programme from the remaining tracks.
In this case, you cannot select “HALF” to specify the tape
length.
You can freely specify the tape length
Set the tape length using ≠ AMS ±.
Example: When the tape length of one side is 30 minutes
and 15 seconds
1 To set the minutes, turn ≠ AMS ±
until “30” appears in the display, then push
≠ AMS ±.
2 To set the seconds, turn ≠ AMS ±
until “15” appears in the display, then push
≠ AMS ±.
When tracks, which aren’t numerically consecutive on
the disc, are programmed consecutively (i.e. 1, 3, 5
etc.)
A one-second access time blank is added between the
tracks.
You can automatically insert a blank space of 3
seconds between each track
Use the Auto Space function (see page 21).
You can check and change the programme
See pages 15 and 16.
Fading In or Out
You can manually fade in or out to prevent tracks from
starting or ending abruptly.
Note that you cannot use this effect when you use the
DIGITAL OUT connector.
CDP-XA50ES
EDIT/TIME FADE
·
0/)
FADER
Number
buttons
0/)
∏
CDP-XA30ES
0/)
·∏
EDIT/TIME FADE
·
P
Press FADER
During pause. “FADE” flashes and
play fades in.
When you want to start fading out.
“FADE” flashes. The play fades out
and the player pauses.
To
Start play fading in
End play fading out