Sony CD-DH790N Stereo System User Manual


 
04/1/28 CD-DH790N_03 EN
E-5
System connections
Supplied FM antenna:
Connect the FM antenna wire to the FM 75 OHMS jack and position the
FM antenna wire in the direction where the strongest signal can be
received.
Outdoor FM antenna:
Use an outdoor FM antenna (75 ohms coaxial cable) for better reception.
When an outdoor FM antenna is used, disconnect the supplied FM
antenna wire.
Supplied AM loop antenna:
Connect the AM loop antenna to the AM and GND terminals. Position the
AM loop antenna for optimum reception. Place the AM loop antenna on
a shelf, etc., or attach it to a stand or a wall with screws (not supplied).
Note:
Placing the antenna on the unit or near the AC power cord may cause
noise pickup. Place the antenna away from the unit for better reception.
The first time the unit is plugged in, the unit will enter the
demonstration mode. You will see words scroll.
To cancel the demonstration mode, press the DEMO button (remote
control) during power stand-by mode. The unit will enter the low
power consumption mode.
To return to the demonstration mode, press the DEMO button again.
The iPod with photo and video can be viewed by connecting to a TV/
monitor.
If the TV/monitor has a video input, connect it to the VIDEO OUT jack on
the rear of the unit.
Note:
Please make sure to set iPod unit to either NTSC or PAL to match your
TV signal. Please visit Apple’s homepage for further information.
After checking all the connections have been made correctly, plug the AC
power cord of this unit into the AC outlet. If you plug in the unit first, the
unit will enter the stand-by mode.
Note:
Unplug the AC power cord from the AC outlet if the unit will not be in use
for a prolonged period of time.
Make sure to unplug the AC power cord before making any connections.
Right speaker
FM antenna
(not supplied)
(not supplied)
screws
wall
< Attaching to the wall >
< Assembling >
AC outlet
(AC 120 V ~ 60 Hz)
Installing the AM loop
antenna
Video cable
Black
Red
Left
speaker
TV
AM loop antenna
To video input
jack
Antenna connection
Speaker connection
Connect the black wire to the minus
(–) terminal, and the red wire to the
plus (+) terminal.
Use speakers with an impedance of 4
ohms or more, as lower impedance
speakers can damage the unit.
Do not mistake the right and the left
channels. The right speaker is the one
on the right side when you face the
unit.
Do not let the bare speaker wires
touch each other.
Incorrect
Do not allow any objects to fall into or to be placed in the bass reflex
ducts.
Do not stand or sit on the speakers. You may be injured.
Demonstration mode
Connecting iPod to a TV
AC power connection