Filter
Top Products
6-4 — Care and Maintenance Smith Corona Corporation
Printwheels
Removing the Printwheel
1. Tilt the sound shield toward you.
2. Remove the ribbon and correcting cassettes.
3. Locate the print hammer release lever (left of the print hammer).
Pull the lever forward until the print hammer mechanism springs
away from the printwheel.
4. Lift the printwheel out.
Inserting a Printwheel
1. Drop the printwheel between the print hammer and the typing
guide with the type style name facing you.
2. Push the print hammer release lever back until the print hammer
mechanism snaps into place.
3. Replace the ribbon and correcting cassettes.
4. Return the sound shield to its original position. The unit should
automatically reinitialize. If this does not occur, check to make sure
the sound shield is closed securely and, if necessary, turn your
machine off, and then on again.