Filter
Top Products
1650 W. Jackson Ozark, MO 65721 (417) 883-4549Rev: 512
3.8 Status Indicators
“CLIP” indicates when Channel 1 is clipping. “PROT” indicates when the power supply protective circuitry has been
engaged. It may be necessary to cycle the power to reset the protective circuitry. “PWR” indicates that power is
present in the amplifier. “SIG” indicates that signal is present at the input of the amplifier.
3.9 Programming Port
This port is used by SLS to program the EEPROM for DSP processing data. It requires a proprietary interface and
is not user assessable.
3.10 Programming Selection
This switch allows the selection between two different EQ settings stored in EEPROM. Pushed in is optimized for a
single PLS8695. Pushed out is optimized for two PLS8695s stacked on top of each other. This is "boot up"
enabled so in order to make the EQ change: power off the PLS8695, select the button position desired and re-
power. It will boot up with the selected EQ programming.
3.11 Mute Switches (in - signal passes, out - muted)*
These switches mute the individual amplifier channels for setup and troubleshooting purposes.
* Buttons are reversed from typical settings to protect them from damage when they are in typical positions.
PLS8695 True Line Source Array Owner’s Manual Page 6
4. Specifications
Product Specifications
Operating Range 80 – 20,000Hz
Horizontal Coverage Angle -6dB 120 Degrees
Vertical Coverage Angle Defined by height of the array
Input Sensitivity 1.88V RMS
Max SPL (calculated) @ 1 Meter 130dB peak
Amplifier Power High Freq. 500 Watts
Amplifier Power Low Freq. 1000 Watts
AC Power Consumption 11 amps at full rated output
Crossover Frequency 1500Hz
Transducers – High Freq. 9 x PRD500 Ribbons
Low Freq. 8 x 6.5 Woofers
Dimensions
55.5” (141cm)H
11.5” (29.2cm)W
12” (30.5cm)D
Weight 110lbs (50kg)
Enclosure
Rugged weather resistant latex
paint - in black, white, or
paintable natural birch