Filter
Top Products
10
Home Distribution Kit Installation Manual
MOUNTING
HOLES
The antenna mounting bracket should be oriented in a vertical position as shown,
and mounted directly to the building or home using the provided #10 screws.
Once you have determined a suitable mounting location, use the mounting
bracket as a template and mark the mounting surface with the location of the
four screw holes in the mounting bracket. Then, using a 3/32 in. drill bit, drill pilot
holes for the screws. It may be necessary to ll the holes with a small amount of
roof cement or caulk to insure a watertight installation. Screw the bracket to the
mounting surface using the provided #10 screws.
Mast Mount
The outdoor antenna can be mounted on most any mast or pole which does not
exceed 2 inches in diameter using the provided U-bolts and mounting brackets.
If you have a satellite TV dish, the outdoor antenna may be mounted on the
same mast as the satellite dish, but remember that the dish cannot obstruct the
antenna’s view of the sky in the direction which you determined from the map in
the previous section.
To mount the antenna to the mast, you will need to use the two provided U-bolts,
the two mounting brackets, and the four hex nuts. Keep in mind that the antenna
cable is routed under the lower U-bolt, in the slot provided in the antenna base as
shown.